how to REMOVE force refresh on 'file not found'

[moov]

how to REMOVE force refresh on 'file not found'
----------------------------------------------------------

Please do you know if it is a BUG? or if that feature will dissappear in the fututre dc++ build;

Or do you know how to remove it?

or do you know how to stop the UPDATE popu up message from previous release of DC++ !

This force refresh disconnect me on most hubs !

bad downloads and bad downloads or
no download !

thx for helping me !

[ender]

the only way it would disconnect you would be if you remove all of your share... in which case you're a leecher and don't deserve to use p2p programs

[moov]

tss ! no !

i don"'t wnat this feautre ; on most deutch hubs when you change the share (after grabing) ....yoiu ra disconnect.

only one second then the dc++ automaticly reconect few minutes after)
but my download slot are "down"
;
SO answer .;please..no comments on why..disconnect ! i don't know why !

[sarf]

Alright. Clearing up the message a bit.

tss ! no !

[I do not want this feature] - on most [German] hubs when you change the share (after [grabbing?]) [you're disconnected].

Only one second then DC++ automatically reconnects a few minutes after -
but my download [slots] are gone

SO please answer [my question] [and please do not not ask why I am disconnected]. I don't know why!

Rrright. I think I know what's happening, but I am not sure of why it is happening. Or rather, I do know why, but it should not be that much of a problem. What happens is this : when a file is not found but it should have been found (e.g. you have a file whis is present in your share but not on your file system) your share is updated. Fine and dandy. But whenever someones share is updated, they resend their share data to the hub. Some hubs do funny stuff when this happens, and kicks you out, whereupon DC++ tries to reconnect you.

If you want to remove this you have to edit the source code and recompile it.

Sarf
---
As long as the answer is right, who cares if the question is wrong?

[ender]

No, that won't solve anything. Complain to the hubowner to fix their scripts, so that they check if the hub is full in the NewUserConnected sub instead of DataArival when $MyINFO is sent.